壓力過濾裝置

      壓力過濾裝置-隨時可以使用

                                       READY-TO-USE PRESSURE FILTRATION UNITS

         這些壓力過濾裝置是為可靠無菌過濾組織方案設計的。過濾面積大、自動排氣、允許高流速。連接一個泵，這些過濾器適合過濾100ml-5L介質和水相溶劑

         These pressure filtration units are designed for reliable sterile filtration of tissure solutions. They have a large filtration area and an automatic venting which allows high flow rates. Attached to a pump, these filters are suitable for the filtration of 100ml up to 5liters of media and aqueous solutions. They come in a polycarbonate hosing and have a female lure lock or hose nipple connector.

SPECIFICATION FOR SCAP

SCAP 參數

      Adsorption                        less than 10 ug per cm2 found in tests with g-Globulin

     吸附作用                         用g-球蛋白測試不小于10ug/cm2

      Bubble Point                     minimum value is 3.4bar （340KPa）

      始沸點                                       zui小值3.4bar（340KPa）

      Connectors                        入口雌魯爾鎖6-12mminlet female luer lock （6-12mm）     

          連接                                 出口加強軟管接頭Out stepped hose nipple （6-12mm）   

     Cytotoxicity             無毒-采用MRC- 5人胚肺細胞non-toxic as confirmed with MRC-5 embryonic lung cells      細胞毒性               and L-929 mouse fibroblast cells                和L- 929小鼠成纖維細胞確認證實

      Extractables             pass the USP plastic test class VI

      萃取物                    通過美國藥典（USP）VI級塑料測試

     Filling volume           6.0ml

      灌裝量                      6.0ml

     Filtration Area           20cm2

      過濾面積                  20cm2

      Flow Rates              typical flow rate for water at 250 ml/min bei △p-1bar（100kPa）

      流速                         典型流速-水--△的P -1bar（100kPa）250毫升/分鐘

     Idle Volume             0.3ml after bubble point, 1.3ml before bubble point

      空閑容量                  泡點后0.3ml,泡點前1.3ml

     Materials                cellulose acetate membrane filter（0.2um）, PTFE vent. filter, polycarnate housing      

      材質                          醋酸纖維素膜過濾器（0.2um），PTFE排氣過濾器，聚碳酸酯室

 Housing                Polycarbonate

 外殼                       聚碳酸酯

     Max.Pressure            max. recommended initial pressure during filtration =bar（300KPa）

過濾工作中*zui大初始壓力300KPa

     zui大壓力                   The hosing withstands at least 5 bar （500KPa） 室耐壓至少500KPa

               北京威斯孚科技有限公司 www.wsf-tech.com;